User's Manual

+ AAA/LR03/R03 1.5V –
+ AAA/LR03/R03 1.5V –
– AAA/LR03/R03 1.5V +
+
–
1.5 V
AAA (LR03)
+
–
1.5 V
AAA (LR03)
+
–
1.5 V
AAA (LR03)
3 x
• When launching the Drone, face the same direction as the Drone. Green blades and
Green LEDs should be in front.
• Practice launching, hovering and landing before attempting to learn other moves.
• Flying 2 to 3 feet above the ground will reduce ground turbulence and make ying
easier.
• When rst attempting to y in different directions, start by tapping the Direction stick
until you have a feel for it. Always move controls slowly until you become comfortable
operating the Drone.
• Once you’ve mastered ying in directions, practice Rotational controls. Spinning and
keeping Drone facing the same direction you are facing makes ying easier and more
intuitive.
• Stay 2 to 3 feet away from walls and ceilings as Drone will be drawn towards them if
you y too close.
• If propeller blades come in contact with another object or you crash, throttle down
immediately to prevent possible or further damage.
• If anything prevents Drone’s blades from spinning or they become jammed, THROTTLE
DOWN IMMEDIATELY. Do not attempt to y until obstruction has been removed and
damage xed.
• Should something prevent Drone’s blades from spinning, Drone may AUTO
SHUTDOWN. The Drone will need to be turned off, then back on, to restore ying
power.
• If the Drone ies too far away, beyond the control range of the remote, the Drone will
AUTO-LAND to prevent the Drone from ying away out of control.
• Occasionally, check that the two halves of the Drone body are not separating. If they
are, simply press gently and snap them back together.
WHEN NOT IN USE:
• Always turn OFF the Remote Control and the
Drone, when not in use or when being stored
or transported.
• Store the Remote Control and Drone in a dry
area at room temperature.
• Avoid temperatures less than 40°F/4°C and
greater than 120°F/49°C.
• Do not leave the Remote Control or Drone in
a car or exposed to direct sunlight. If
exposed to temperatures greater than
120°F/49°C, the Remote Control or Drone
batteries can be damaged or may catch
re.
AUTO SHUTDOWN:
• If battery voltage drops to an extremely low level, Drone will
automatically shutdown. The Nano Drone will need to be recharged to
restore ying power.
• If anything prevents Drone’s blades from spinning or they become
jammed, Drone will automatically shutdown. To restore ying power, turn
OFF the Drone and then turn it ON again.
FLYING TIPS
Loosen screw in the Remote Control battery
compartment door with Philips screw driver and
insert batteries as shown. Replace door and
tighten screw.
INSTALLING REMOTE BATTERIES
OFF
ONOFF
3 8
SIZE: 297 x 210mm (folds to 148.5 x 210mm)
PAGE 3 / PAGE 8
2B