User's Manual

9
2
ONE-TOUCH STUNTS
CAUTION
NOTE: Once a stunt has been initiated, DO NOT adjust Throttle or press any other
controls until the stunt has been completed).
FLIP FORWARD
Tap Direction stick UP while pressing Stunt Button.
FLIP BACKWARD
Tap Direction stick DOWN while pressing Stunt Button.
FLIP LEFT
Tap Direction stick LEFT while pressing Stunt Button.
FLIP RIGHT
Tap Direction stick RIGHT while pressing Stunt Button.
Quadcopter should be flying at least 9 feet in the air with a minimum
clearance of 9 feet in all directions before attempting stunt functions.
STUNT FUNCTIONS SHOULD BE PERFORMED OUTSIDE ONLY.
WARNING
IF AT ANY TIME DURING CHARGING OR USE THE BATTERY BEGINS TO SWELL OR
BECOMES DAMAGED IN ANY WAY, DISCONTINUE CHARGING OR USE OF THE
BATTERY IMMEDIATELY. Continuing to charge or discharge a battery that has begun to
balloon or swell can result in a fire. Quickly and safely disconnect the battery and place it
in an open, safe area away from flammable materials. Observe the battery for at least 30
minutes to be certain no additional swelling or rupture occurs. Completely discharge the
battery by submerging it in a saltwater solution (1/2 cup salt per gallon of water) for 24
hours. Check your local laws and regulations for correct recycling and/or battery disposal.
CHARGING, INSTALLING & CARING FOR LiPo
BATTERY IN QUADCOPTER
NOTE: Always unplug LiPo battery when
Quadcopter is not in use.
CHARGING PRECAUTIONS:
After use, allow LiPo battery to cool to room
temperature before charging.
• Charge LiPo battery in an isolated area,
away from excessive heat or moisture.
• Never leave LiPo battery unattended while
charging.
• If LiPo battery swells, unplug it immediately
and permanently discontinue use.
Pull LiPo battery out of underside
of Quadcopter.
Plug charging cord into a computer or
USB power block.
Plug LiPo battery into Charging Cord.
RED LIGHT = CHARGING
GREEN LIGHT = FULLY CHARGED
Once charged, disconnect LiPo battery
from USB port.
Unplug charging cord from USB power
source. (Always unplug when not in use).
Insert LiPo battery into back of Quadcopter
press battery firmly into socket to ensure
the plug is fully attached.
1
2
3
4
5
6
2A
INSTALLING REMOTE BATTERIES
Loosen screws in remote battery
compartment door and insert
batteries as shown. Replace
doors and tighten screws.
+
-
AAA (LR03)
1.5 V
4 x
CHARGING
CORD
LiPo BATTERY
A
B
C
D
D
LiPo
BATTERY
CHARGING
CORD
SIZE: 297 x 210mm (folds to 148.5 x 210mm)
PAGE 9 / PAGE 2