User Manual

CONNECTING THE CHARGER
CONNECTING THE BATTERY
Balance socket:
Using terminal
clip attaching
to car battery
The balance wire attached to the battery must be connected to the charger with the black
wire aligned with the negative marking. Take care to maintain correct polarity! (See the
wiring diagram below.)
This diagram shows the correct way to connect your battery to the SKYRC QUATTRO
B6AC while charging in the balance charge program mode only.
WARNING:
Failure to connect as shown in this diagram will damage this charger.
SKYRC QUATTRO B6AC comes with the built in switching power supply. You can connect
the AC power cord directly to the main AC socket. (100-240V AC) For attaching directly to
12V car batteries. It is critically important that you use a fully charged 13.8V car battery .
Important!!! Before connecting a battery it is absolutely essential to check one last time
that you have set the parameters correctly. If the settings are incorrect, the battery may
be damaged, and could even burst into flames or explode. To avoid short circuits between
the banana plugs, always connect the charge leads to the charger first, and only then to
the battery. Reverse the sequence when disconnecting the pack.
LITHIUM BATTERY(LIPO/LILO/LIFE)PROGRAM