User's Manual

10
NC2500
09
NC2500
Useful notes and tips
You can only connect your NC2500 charger with one device at a time.
The charger can hold up eight paired devices. When the memory is full and additional device cannot
be paired. If you want to pair new devices, you need clearing all the memory.
Clearing memory
To clear the charger memory of all devices, Press and hold “UP” and “DOWN” button simultaneous
for five seconds, The charger clears all devices from its memory.
Touch slot number button(1-4) to change operation mode and current.
Touch system setting icon to change value of temperature protection,
discharge cut-off voltage, delta V.
Operation with Your iPhone
When the program for a slot is completed, DONE will displayed. With the
exception of DISCHARGE mode, topoff charge and trickle charge (continuous)
will be applied. For CHARGE mode, the total charged capacity will be displayed.
For REFRESH & ANALYZE, BREAK-IN, DISCHARGE mode, the total discharge
capacity will be displayed.
DisCharge Rate
mAh
DISCHARGE
REFRESHIST.
BREAK-INO.
REST CYCLE
Capacity
Volt Time
For CYCLE mode, the discharge capacity of the final cycle is displayed. “HIST. ” icon will
also be shown. Use the UP and DOWN button to access discharge capacity for all the cycles
performed. The capacity information will be stored as long as the battery is inserted in the charger. It
will be lost upon removal of the battery.
CYCLE
OPERATION WITH iPHONE
Pairing Charger with iPhone
Pairing occurs when two Bluetooth devices communicate with each other and establish a connection.
A record of information about this connection is then stored in the memory of each device. Once you
pair a device with the NC2500 charger, you should not have to pair it again.
The NC2500 charger can pair with up to eight devices. However, it can only connect to, and control
the NC2500 charger from one device at a time.
To begin pairing with your iPhone, iPod or iPad
Connect the power adapter DC connector to the charger and then plug the power adapter into
outlet (100-240V AC, 50/60Hz).
Insert AA or AAA battery
Inserting AA or AAA Batteries
1.
2.
When a new battery is inserted and detected, the
battery sign and “CHARGE” in correspond slot will
blinking. Please wait five seconds, the charger will
proceed to the default mode which is charging.
Push and hold “ENTER” button for five seconds, the
bluetooth LED indicator on the charger is blinking in
blue to show the charger is discoverable.
3.
Select the Bluetooth menu from your iPhone or iPad and ensure the Bluetooth is turned on.
4.
Find the NC2500 Charger which will be identified as “SkyRC + 4 digits serial number”. For
example, SkyRC1234 and select it.
Confirm that you want to connect the NC2500 Charger with your iPhone or iPad by selecting it.
5.
A confirmation “Connected” appears on your phone after you have selected the NC2500 Charger.
It takes few seconds to finalize the pairing process, please wait for while.
The Bluetooth indicator, located on the right side of charger remains steadily on.
Your NC2500 Charger is now connected with your iPhone or iPod.
6.
7.
8.
OPERATION WITH iPHONE OPERATION WITH iPHONE
Factory default
setting