INSTRUCTION MANUAL AA/AAA NiMH/NiCd BATTERY Manufactured by SKYRC TECHNOLOGY CO., LTD. www.skyrc.com 2013 SkyRC Technology Co., Ltd. All Rights Reserved. 7504-0215-01 Version 1.
INDEX INTRODUCTION & GENERAL PRECAUTIONS Introduction 02 General Precautions 02 Features 03 Specification 03 Information Display On Charger & Smart Phone 04 INTRODUCTION Thank you for purchasing the SKYRC NC2500 Charger-Analyzer which enables quick and optimum charging of “AA” and “AAA” rechargeable batteries.
FEATURES & SPECIFICATION GENERAL BATTERY KNOWLEDGE FEATURES INFORMATION DISPLAY ON CHARGER & SMART PHONE Four independent slots There are four independent charger-analyzers for AA and AAA NiMH/NiCd batteries. Larger LCD display with backlit for easy reading. Digitally display various modes during operation.
MODES OF OPERATION OPERATIONS STEPS MODES OF OPERATION OPERATIONS STEPS This section explains various modes and when to use them. To enable each mode, refer to the “Operation” section. 1. Charge: Charge the battery at the selected rate. Suitable for batteries used frequently. 1. Connect the power adapter DC connector to the charger and then plug the power adapter into outlet (100-240V AC, 50/60Hz). 2. Insert AA or AAA battery 2. Discharge: Discharges the batteries at the selected rate. 3.
OPERATIONS STEPS DISPLAY INFORMATION 5. If DISCHARGE mode is selected: The charger will prompt for discharging rate by flashing “DisCharge Rate”. Use UP and DOWN button to choose the desired current. Press ENTER to make the selection. Increase discharge DisCharge Rate rate Capacity VoltTime DisCharge Rate Capacity VoltTime mAh mAh ENTER DISCHARGE REFRESHIST. BREAK-INO. REST CYCLE Decrease discharge rate ENTER DISCHARGE REFRESHIST. BREAK-INO.
OPERATION WITH iPHONE OPERATION WITH iPHONE For CYCLE mode, the discharge capacity of the final cycle is displayed. “ HIST. CYCLE” icon will also be shown. Use the UP and DOWN button to access discharge capacity for all the cycles performed. The capacity information will be stored as long as the battery is inserted in the charger. It will be lost upon removal of the battery. When the program for a slot is completed, DONE will displayed.
OPERATION WITH ANDROID PHONE OPERATION WITH ANDROID PHONE Touch “Details” icon to show voltage graphic and battery internal resistance. Touch system setting icon to change value of temperature protection, discharge cut-off voltage, delta V. Factory default setting 0.9V Touch “Details” icon to show voltage graphic and battery internal resistance. OPERATION WITH ANDROID PHONE Pairing Charger with Android Phone 1.
WARRANTY AND SERVICE CHARGING TIME WITH VARIOUS CHARGING CURRENT CONFORMITY DECLARATION SKYRC NC2500 satisfies all relevant and mandatory CE directives and FCC SubPart C Intentional Radiators section 15.247 The product has been tested to meet the following technical standards: Title Result EN 300328 Wideband transmission systems; Data transmission equipment operating in the 2,4 GHz ISM band and using wide band modulation techniques article 3.
