User's Manual

· 24
DC Power Supply
Operating Instruction
BATT/PROGRAM
SYSTEM SETTING->
DC SUPPLY: 20W
CHA: 50 CHB: 30W
ENTER
Press the ENTER to enter the DC Power Supply program
Set the output power for the DC charger or other devices. (please
note the voltage is 13.8V)
Set the power of channel A and channel B, the power supply will
take the rest power automatically.
Caution: The maximum DC Power output is 100 Watts and the maximum current is 10A.
Please check the total loading of your equipments before using DC power supply.
If the loading of DC power supply is over 100W, the led light will flash red.
ENTER
CH1: 50 CH2: 50W
DC SUPPLY: 150W
D100 V2
To use D100 V2 as a power supply, the user must connect it to AC power source. When
the green LED on the back side turns on, then the user is free to use the power supply,
the power of DC output is adjustable from 10W to 100W. The output voltage is 13.8V. The
power of DC output is shared with charger power. When you increase the power of DC
output, the charger power will be decreased accordingly. (DC Power + Channel
A+Channel B Power = 100 Watts)
OFF
Green
Yellow
Red
Red Blinking
DC Power Off
0-30% Loading
31-60% Loading
61-100% Loading
Over Load
EXPLANATION OF LED STATUS