User's Manual

48
49
Mobile device will not
connect to the head unit
automatically
When the Connect function is set to Manual,
the head unit will not connect to any mobile
device automatically
Set Connect Function to Auto as described on page 37
Ring tone cannot be heard
through the speakers
Ring tone volume is turned down
Increase the volume of the ring tones using the up and
down volume control during the ringing process
MUTE function is activated in the head unit
Press MUTE to cancel the mute function and resume audio
Echo or noise is heard
during a phone call
Possible road noise or interior interference
Close all windows and turn off any fans or A/C
Microphone opening on the front panel is
obstructed
Clear any obstacles in front of microphone opening
Call is connected (but no
audio can be heard through
the speakers)
Audio is routed to the mobile device
Press Audio Transfer to allow audio from the
phoneto be heard through the speakers
Call is answered
automatically
Auto Answer function is set to ON
Set Auto Answer function to OFF as described on page 39
Caller ID does not appear
during incoming call
The calling mobile device is not set to send the
Caller ID or the service is not available
Some devices may not communicate or work
properly with this head unit
Remote control
does not function
Battery is covered with insulation tape
Pull out the insulation tape
Battery depleted
Replace battery with new one
Battery installed incorrectly Remove battery and install correctly
Remote
To first use the IR Remote
control, you must first pull
t h e b a ttery insulation
tape out.
I n s e r t / R e p la c i n g t h e
Battery:
R e m o v e t h e b a t t e r y
holder
Remove the battery from
the battery holder
Install the new battery
Make sure the (+) side
faces up
Insert the battery holder
Notes:
Remove the battery if the IR Remote will not
be used for a month or longer
Remove and dispose of battery properly
CAUTION!!!
Do not store battery
with metallic objects or
materials.
IR Remote Preparation