User's Manual

Operation instructions
TYPICAL FRONT-LOAD DIN MOUNTING METHOD
After installation and connections
1.Start the car’s engine.
2.Verify that the brake lights, other lights, horn, turn indicators, and all other electrical parts operate
normally.
3.Use a mechanical-pencil or similar to push the Reset button on the unit.
Detaching the front panel
You can detach the front panel of this unit.
1. Press
The unit is turned off.
2. Press
POWER
RELEASE
Notes:Do not drop the front panel or put excessive pressure on them.
Do not subject the front panel to heat/high temperature or moisture. Avoid leaving it in a parked car
or on a dashboard/rear tray.
Resetting the unit
Before operating the unit for the first time, or after replacing the car battery or changing the connections,
you must reset the unit.
Detach the front panel by pressing RELEASE and pull it off towards you .
Use a pointed object such as a mechanical pencil to push the Reset button. To avoid the possibility of
damage, you should not use a needle or push the button too strongly.
Push Reset
Notes:When the Reset button is pushed, the time and all stored settings are lost and will have to be
reprogrammed.
The reset procedure takes about 3 seconds after the Reset button is pushed.
When the reset procedure is completed, press OPEN/CLOSE an verify that the monitor oper, close
the monitor once. Otherwise, it may not operate properly.
POWER RELEAASE
Reset button