User's Manual

Note:
The remote control uses one 3 volt Lithium CR2025 battery. For best performance, replace only with
CR2025 or equivalent.
Installing the main unit
After all connections are made, install the main unit to the dashboard.
Before installation
This unit is designed to be completely safe, but if not installed correctly, it can cause accidents. Be sure to
verify the following points before installation.
Install the unit so that the monitor when opened up will not block access to the hazard switch or other
important controls.
Do not install the unit (monitor) in locations which maybe subject to excessively low or high temperatures.
(Otherwise the unit may be deformed and the LCD may be damaged.)
Exposure to direct sunlight can also lead to high temperatures and should be avoided.
Selecting the installation location
1.Set the ignition key to OFF or remove it.
2.Place the units in their intended mounting locations to check the cable length and monitor installation
conditions.
Installation procedure precautions
Perform the installation carefully. Dropping the unit or otherwise subjecting it to strong impact or force
may deform the chassis, resulting in failure of the monitor loading mechanism or other defects.
To allow for proper opening and closing of the monitor, there must be a clearance of at least 170 mm
between the closest position of the shift lever and the mounting surface for the unit.
In some cases, the shift lever may touch the monitor when moved to a certain position. Make sure that
there is no obstruction to driving operations.
The unit should be installed within an angle of 30 degrees from horizontal. If this angle is exceeded, the
monitor may not open up or retract properly.
Installation procedure
When installing this unit, be sure to close the monitor of the unit.
If the monitor is opened while installing and given too much force, it may cause a malfunction.
Remove the four #1 phillips head screws from each corner, and slide the unit out of the mounting sleeve.
Install mounting sleeve into opening, bending tabs to secure.
Connect wiring harness and antenna as shown on pages 9-10. Consult a qualified technician if you are
unsure.
Certain vehicles may require an installation kit and/or wiring harness adapter (sold separately).
Test for correct operation and slide unit into mounting sleeve, secure with #1 phillips screws as removed in
step 1.
Snap trim ring into place.
Wiring Diagram - Optional A/V Connections
Front Amplifier
Rear Amplifier
Sub Amplifier
Headrest Monitor
Optional Backup
Camera