User's Manual

Preventing accidents
The video pictures appear only after you park the car and set the parking brake.
When the car starts moving, the video pictures automatically disappear for safety reasons, after
displaying the following caution.
Do not watch the monitor while driving. You may cause a traffic accident if your attention is distracted by
the monitor.
CAUTION
IT'S UNLAWFUL TO OPERATE A VEHICLE WHILE VIDEO IS DISPLAYED IN THE
DRIVERS VIEWING AREA.
ENGAGE EMERGENCY BRAKE TO ENJOY VIDEO
Do not use the System Setup feature while driving, or perform any other function which could divert your
attention from the road.
When you connect the back camera:
When you drive, watch the surroundings carefully for your safety. Do not depend on the back camera
exclusively.
When backing up you car, be sure to look back for your safety.
Do not touch the liquid crystal fluid if the LCD is damaged or broken. The liquid crystal fluid may be
hazardous to your health or fatal. If the liquid crystal fluid from the LCD contacts your body or clothing,
wash it off with soap immediately.
On installation
Due to its technical nature, it is highly recommended that your EXONIC EXD 7090 is installed by a
professional installer or an authorized dealer. This product is only for use in vehicles with 12VDC negative
ground only.
If you try to install this unit by yourself, refer to the supplied “Installation/Connections” manual and read it
carefully. Make sure to install this unit properly.
Improper installation may cause a short circuit.
If the unit does not work properly, check the connections first (refer to the supplied “
Installation/Connections” manual). If everything in order, check the fuse.
Replacing the fuse
When replacing the fuse, be sure to use only a fuse of the same rating (ampere rating).
Using a different fuse or bridging the contacts with wire is highly dangerous and can lead to serious
damage.
To prevent short circuits when replacing a fuse, disconnect the wiring harness first.
Protect unit surface from damage
Do not expose the unit surface to chemicals such as insecticide, hair spray, insect repellent, etc.
Do not leave rubber or plastic materials in contact with the unit for along tine. Otherwise the finish of the
unit may be impaired, or deformation may occur.
When installing, be sure to turn the ignition key to the off position. Installing the unit while the ignition is on
may cause battery drain or short circuit.
When installing, be sure not to damage any car parts such as pipes, tubes, fuel tank or wiring by using a
drill. It can cause a fire or an accident.
Do not attempt to open or repair the device yourself. This work should be performed by an authorized
service agent.
Installing location
Do not install this unit where:
The driver s view will be obstructed when the monitor is in either open or close position.
The operation of the car or the airbag system will be obstructed.
It will obstruct the operation of the vehicle, especially the steering wheel, shift lever or brake pedal.
Moisture condensation
When the temperature of the unit falls (as in winter), the liquid crystal inside the screen will become darker
than usual. Normal brightness will return after using the monitor for a while.
To maintain high sound quality
Be careful not to splash juice or other soft drinks onto the unit or discs.
Playable discs
The following types of discs/files are compatible:
CD-ROM (ISO), CD-R, CD-RW, DVD+R/RW, DVD-R/RW
CD-DA, DVD Video
MP3 data
JPG images
The following types of discs/files are not compatible:
WMA files that are protected by DRM (Digital Rights Management)
WMA lossless format
Discs recorded with Track At Once or packet writing
MP3 PRO format
MP3 playlists
WAV format
WMV format
AVI format
Some recordable DVDs and CDs may be incompatible with this unit, depending on media type and
recording method.
Notes:
If you experience problems during installation, contact your nearest EXONIC dealer.
If the unit malfunctions, reset the unit as described on page 11 first. If the problem still persists,
contact your nearest EXONIC dealer.