User's Manual

NX501/NZ501
43
English
English
Owner’s Manual
15. RADIO OPERATIONS
Listening to the Radio
1. Touch the Tuner button on the Main menu display.
The tuner mode screen is displayed.
2. Press the [FM1/2/3/AM] button or touch the [Band]
key on remote control to select the radio band. Each
time the button is pressed, the radio reception band
changes in the following order: FM1->FM2->FM3->AM
->FM1...
1. Preset Scan Button
2.Direct Button
3.Preset List Button
4.Frequencies Display
5.Tune Up
6.Tune Down
7.Band Display
8.LOC/DX Display
9.Bluetooth Display
10.System Time
Seek Tuning
1. Press the [FM1/2/3/AM] button to select the radio
band (FM or AM).
2. Touch the [ =KEYAND THENFLICKTHE")'
Frequency up and down to search for next available
station.
s7HENmICKTHEFREQUENCYUPTHESTATIONISSEARCHED
in the direction of higher frequency.
s7HENFLICKTHEFREQUENCYDOWNTHE STATIONIS
searched in the direction of lower frequency.
Step Tuning
Press the [FM1/2/3/AM] button to select the radio
band (FM or AM).
2. Touch the [
=OR; =KEYINFREQUENCYPANELTOTUNE
up or down by one step.
Recalling a preset station
Press the [FM1/2/3/AM] button to select the desire
band (FM or AM) on the tuner.
Touch the [
=KEY0RESSTHEPRESETSTATIONTO
on preset list.
3. Press the [
=KEY THENPRESSTHE ; =BUTTONTO
auto search and store the stations.
Manual memory
1. Touch the desired Band key to select the band you
wish to store.
2. Tune to a station you want to store using the seek
tuning, step tuning, or preset tuning.
3. Touch and hold the desired Preset key you want to
store for about 3 seconds.
Auto Store
The Auto Store is a function for storing up to 6 stations
that are automatically searched in sequentially. If the
number of receivable stations cannot reach to 6, the
previous stored station remains.
1. Touch the [FM1/2/3/AM] key to select the desired
band. (FM or AM)
2. Press the [
=KEYANDTHENPRESSTHE; =KEYTO
start the Auto Store.
A beep sounds and the stations with good reception
are stored automatically to the preset list.
Preset Scan
The Preset Scan receives the stations stored in the
preset memory in order. This function is useful when
searching for the desired station in memory.
1. Touch the [FM1/2/3/AM] key to select the desired
band. (FM or AM)
2. Touch the [
=KEYTOSTARTTHE0RESET3CAN
The unit starts scanning each station for 10 seconds
sequentially. But the station stored is not a valid
station; the scanning time is only 2 seconds.
3. When the desired station is tuned in, touch the
[
=KEYAGAINTOSTAYINTHATSTATION
LOC/DX Setting
1 32
8 9
4
6
5
10
7
1;B1=࣫㕢⠜䇈ᯢкLQGG 