User's Manual

Compass Variance
To adjust compass variance, touch
the SELECT icon to display
adjustment data.
• Touch the icon or to set the desired declination.
• When the declination has been completed, touch the “SET” function icon.
Setting the Declination
The declination is the difference between true north (the direction of the geographic
north pole) and where a compass needle points to. Since the declination varies from
place to place, it needs to be for each region. Otherwise the compass will not show the
declination by the following steps:
NOTE:
• The default declination setting is 0 degrees. In accordance with the illustration, set the
declination setting to the declination contour nearest to a region where you drive the
vehicle.
• The declination can be set at intervals of 1 degrees, from 28 degrees west (W28) to 28
degrees east (E28).
Compass Calibration
touch the SELECT icon to display
“CALIBRATION READY”
• Touch the SELECT icon again to
display “Please drive slowly in a
safe open area”
• Turn the vehicle slowly through
360 degrees in a safe open field
with no buildings and other
vehicles.
• If you wish to stop calibration the compass part-way through the procedure, the
compass may not be properly calibrated in this case, you must turn the vehicle
through 360 degrees.
NOTE:
Barometer Adjust
This display shows the atmospheric pressure at the present location. The atmospheric
pressure values are read every 5 minutes.
fig. 59
To Calibrate compass:
fig. 61
fig. 62
fig. 60
21
• Touch the icon or to set
the desired value.
• Touch the “SET“ icon to complete
the input date.
Barometer Default
To Set Barometer Default, touch the
SELECT icon to display “Current
Value: ___hPa REALLY?”
• Touch the “SET” icon to display the
default Barometer Value “CURRENT
VALUE:1006hpa”
• To return to Car info, touch EXIT
Range: This shows the distance (in km) that can be driven on the fuel
remaining in the fuel tank. The driving range is read every 5 minutes.
NOTE:
• When the vehicle is fueled, the driving range will be updated. However, if the amount of
fueling is small, the indication may not be correct. It is recommended to fill the tank as
much as possible.
• The driving range is shown based on the accumulated fuel consumption data, However,
it may change depending on the driving condition (road condition, driving behavior,
etc.). If the battery terminals are disconnected, the accumulated fuel consumption data
will be erased. It is recommended to use the indication as reference.
• When the vehicle is stopped on a steep slope, the value of the driving range may
increase. This is caused by the fuel movement inside the tank on the slope and is not
deemed as a failure. ( malfunction )
Speed: The average value of the speed is read every 5 minutes.
Resetting the average speed:
• Touch the icon
on the screen.
• Touch the “RESET” icon on the
screen.
NOTE:
• When you turn the ignition switch to the “ON” position about 4 hours (or more) after
turning it from the “ON” position to the “ACC” or LOCK” position, the average speed
indication will automatically be reset.
fig. 63
fig. 64
fig. 65
fig. 66
fig. 67
22