User Guide

20
20
When the DONE button is pressed, the filter timer will reset and the air will be removed from
the filter circuit. If the required vacuum is not reached in the time allowed, the screen will
display the following message and the machine will stop.
Check to be sure that the filter is installed correctly and that the “O” ring seal is not damaged.
When the leak has been fixed, press the CONTINUE button to restart the air removal process.
When the air has been removed from the filter circuit, the screen will display the main menu.
Install the filter cover and tighten the screws.
FLUSH PROCEDURE
WARNING: THIS IS A CLOSED LOOP FLUSH FOR THE REMOVAL OF AC
SYSTEM OIL ONLY. DO NOT
USE THIS FUNCTION IF YOU
SUSPECT PARTICULATE CONTAMINATION FROM A
CATASTROPHIC COMPRESSOR FAILURE OR SIMILAR
MALFUNCTION. ALWAYS USE AN IN-LINE FILTER WHEN
FLUSHING TO PREVENT DAMAGE TO YOUR MACHINE.
When FLUSH is selected the following screen will be displayed.
Press the continue button to display the following screen.
Press continue to display the next screen. It will allow you to set the charge amount and start
the charge process. IMPORTANT: USE DOUBLE THE NORMAL CHARGE AMOUNT FOR
THE VEHICLE.
YES
SYSTEM TIMED OUT
CHECK FOR LEAKS
CONTINUE
!!Caution!!
Use ONLY for oil removal
CONTINUE
OPEN TANK LIQUID VALVE
CONTINUE