User Guide

Check for leaks at the hose connection points and ABB valves. This will be the most likely

area where leaks will occur. Also check the tank liquid valve to be sure it is closed. If the

service hoses are leaking at the vehicle end, disconnect the hoses from the machine, cap the

ports and restart the change procedure from the main menu. Repair or replace the hoses as

soon as possible. If a leak is located in the machine, call the SKYE toll free tech line (1-800-

722-7593) for immediate assistance.

CHANGE FILTER PROCEDURE

CAUTION: HIGH PRESSURE REFRIGERANT MAY BE PRESENT. DO NOT ATTEMPT

TO REMOVE THE FILTER UNTIL INSTRUCTED. USE SKYE PART # 256100

ONLY.

When CHANGE FILTER is selected the screen will display the following instructions.

Press the DONE button when the tank valves are as instructed. The machine will start and

clear the refrigerant from the filter circuit. You may remove the filter access cover at this time

by loosening (DO NOT REMOVE) the retaining screws located on the bottom of the metal box.

Turn or twist the cover counterclockwise to remove it. When the filter circuit is free of

refrigerant the next screen will be displayed.

When the power cord has been disconnected, remove the old filter (use an adjustable wrench

to loosen the filter) by turning it counterclockwise. Unpack the new filter, lubricate the “O” ring

seal with refrigerant oil and install it. Tighten the filter by hand then use the wrench to “snug” it

up. DO NOT OVER TIGHTEN THE FILTER.

When installation of the filter is complete, connect the power cord and turn the main power

switch on. The screen will display the following message.

FILTER LIFE HAS EXPIRED

REMOVE SERVICE HOSES FROM VEHICLE – CLOSE

TANK LIQUID VALVE – OPEN TANK VAPOR VALVE

FILTER HAS BEEN CHANGED

PRESS YES BUTTON TO RESET THE FILTER TIMER

AND START UNIT VACUUM.

DONE

READY TO CHANGE FILTER

TURN OFF AND DISCONNECT POWER NOW

MAIN