User's Manual

Table Of Contents
7. You can change the mode of the mask if you need to change how a mask is applied by clicking the
Invert button. By default, the Radial Gradient mask that is created will “protect” the center of the
circle/oval and any enhancements will be applied outside of the inner circle. Click this button to invert
the mask so that effects will be applied to the inner circle.
8. You can also adjust properties like Blending modes and Opacity to change the masks impact on the
image.
9. When satisfied with the mask, click the Done button.
10. If using an Adjustment Layer, adjust the Filter controls as needed. The mask will control how its
results are applied.
Tip
You can edit the results of a Radial mask by clicking the Edit Mask button. This lets you
add or subtract from the mask using the Brush tool for greater control over the mask.
*
Skylum Luminar - 4
©2020 Skylum Page 225 of 309