Instructions / Assembly

Reset PIN to factory default

1. Undo the screw an the bottom of the keypad and remove the battery.

2. Press and hold [*] and [#] while battery is removed.

3. While holding on to both buttons, insert the battery.

4. Keep holding both buttons for about 5 seconds until you hear a long beep.

The PIN is now reset to 0 0 0 0. Attach the keypad to the back plate and

secure the screw at the bottom.

Re-program the keypad to the garage door opener following the

instructions on page 22 “Programming remote / keypad”.

Enable Multiple Doors Operating Mode

This keypad can operate up to 4 Skylink garage door

openers. To enable

multiple doors mode:

1. Enter [PIN] [*] [9] [#].

2. You will hear 2 beeps indicating keypad is now in multiple doors mode.

Program keypad in Multiple Doors Mode to Garage Door opener

1. Press “SET” button on the garage door opener, LED display will show “P”.

2. Enter [PIN] [#] [Door #], Door # is either [1], [2], [3] or [4]

To control Multiple Doors:

Enter [PIN] [#] [Door #].

For example, to control door 2, enter [PIN] [#] [2]

Disable Multiple Doors

1. Enter [PIN] [*] [0] [#].

2. Press [0] [#]. You will hear 2 beeps indicating keypad is now in multiple

doors mode.

Keypad (Optional)

OPERATION