Instructions / Assembly

CAUTION
1. Lay the chain / belt beside the rail as shown.
2. Grasp the turnbuckle connector [K2] at the end of the
chain / belt assembly, pass it through the window.
3. Position the trolley assembly [J3] near the door end. Pull the
chain assembly (cable end) / belt around the idler pulley [J2]
and feed through the trolley. Place the turnbuckle connector
2ft from idler pulley.
Note: The cable on the chain assembly, or the ribbed side
on the belt assembly must contact the pulley.
4. Grasp the turnbuckle [K3] and dispense the remainder of
the chain assembly / belt along the rail tow
ard the motor unit around
the sprocket assembly and continuing to the turnbuckle
connector. The sprocket assembly [J4] teeth must engage
the chain / belt.
5. Hook the turnbuckle into the turnbuckle connector.
To avoid possible SERIOUS INJURY to finger from moving
garage door opener:
• ALWAYS keep hand clear of sprocket, chain / belt or any
moving parts while operating opener.
• Securely attach sprocket cover BEFORE operating.
Step 3 – Install the chain / belt
10
ASSEMBLE THE RAIL