Instructions / Assembly

1. Attach Emergency Release Rope 3. Connect the Door Arm to the Trolley

4. Connect the Door Arms Together

Bring two arms together. Find two pairs of holes that line up and join 2 arms with bolts and nuts.

Select holes as far apart as possible to increase door arm rigidity.

2. Connect the Door

Arm to Door Bracket

Sectional Door

Connect the curved door arm to the door bracket

with clevis pin and hitch pin.

One-piece Jamb Door

Connect the straight arm to the door bracket

with clevis pin and hitch pin.

One-piece Jamb Door

Connect the curved door arm to the trolley with

clevis pin and hitch pin.

Sectional Door

Connect the straight door arm to the trolley with

clevis pin and hitch pin.

Sectional Door One-piece Jamb Door

NOTE:

• Emergency release handle should hang 6’ (1.8 m) above floor. Adjust rope length if it is

necessary.

WARNING

• Use extreme care when pulling release handle. DO NOT use handle to pull door open or close.

• Never use emergency release handle unless garage doorway is clear of persons and

obstructions.

INSTALL THE DOOR ARMS

2121 2222

B8 X2

B2 X2

B9 (X1)

B6 (X1)

Engaged

Released

E1 (x1)

E2 (x1)

F2(x1)

F1(x1)

F3 (x2)

F4 (x2)

F3 (x2)

F4 (x2)

Thread the red rope through the hole in

the trolley release handle and tie an

over-hand knot. Leave the trolley release

lever in the released position until further

testing is completed.