Lacey Act Declaration Form

CUSTOMER SERVICE
17 Sheard Avenue, Brampton, Ontario, Canada L6Y 1J3
Email:[e-mail]
http://www.skylinkhome.com
P/N. 101Y106
® are registered trademarks of their respective corporations
©2013 SKYLINK GROUP
11. FCC
The Garage Door Remote Control is approved by the FCC and it complies with
Part 15 of the FCC Rules. Its operation is subject to the following two conditions :
1. This device may not cause harmful interference.
2. This device must accept any interference that may cause undesired operation.
WARNING:
Changes or modifications to this unit not expressly approved by the party
responsible of compliance could void the user’s authority to operate the equipment.
12. WARRANTY
If, within one year from date of purchase, this product should become defective
due to faulty workmanship or materials, it will be repaired or
replaced, without charge. Proof of purchase and a Return Authorization are required.
13. CUSTOMER SERVICE
If you would like to order Skylink’s product or have difficulty getting your Skylink
remote control to work or download information and user manual, please :
1. visit our FAQ section at
www.skylinkhome.com, or
2. email us at
[e-mail], or
3. call our toll free at 1-800-304-1187 from Monday to Friday, 9 am to 5 pm EST.
Fax [phone]
5. INSTALLATION
You can mount the keypad transmitter on a desired location with the
screws provided.
Undo the screw from the bottom of the case. Remove the back cover
from the keypad.
Secure the back cover on a desired location with the screws. Re-install
the keypad unit to the back cover. Tighten the screw at the bottom
of the case.
Q: Door opener does not react after pressing the button on the keypad
transmitter?
A: - Ensure you hear 3 beeps from the keypad transmitter after entering
the [Password][#] or [Password][#][Door Number] for multiple door
operation. If you don't hear 3 beeps, that means you have entered
the incorrect password. Re-enter the password.
- Ensure the keypad transmitter has been programmed to the Smart
Button or garage door opener. Refer to section 4 for how to
program a keypad to the receiver.
6. TROUBLE SHOOTING
7. REMOVE THE KEYPAD TRANSMITTER FROM
THE GARAGE DOOR RECEIVER
You can delete the keypad transmitter(s) from the garage door receiver.
Refer to the manual of the garage door receiver to erase the keypad
transmitter.
8. CHANGE PIN
Follow the instructions below to change the PIN.
To change your PIN:
1. Enter the current PIN, (factory default PIN 0 0 0 0), press * .
2. Enter new 2 to 8 digit PIN, press * .
3. Enter new PIN again, press * .
For example, if you are changing the PIN number from 0000 to 123456,
enter the following sequence, 0000, *, 123456, * , 123456, * .
If the Keypad emits 3 beeps, your pin has been successfully changed.
If the pin is different from step 2, the keypad will emit a long error beep
and you have to re-start from step 1.
9. BATTERY
One 1.5 volt Alkaline type (AAA size) battery required.
10. WARNING
DO NOT let children use the garage door transmitter without adult supervision.
Children can injure themselves or others by the garage door.
It is time to change the battery when the
backlight no longer appearing.