User's Manual

8
SKW92-UM-001,A/1
SKYLAB M&C Technology Co., Ltd SKW92-User Manual
Skylab M&C Technology Co., Ltd.
ThisdeviceisintendedonlyforOEMintegratorsunderthefollowing
conditions:
1) Theantennamustbeinstalledsuchthat20cmismaintainedbetweentheantenna
andusersc.
2) Thetransmittermodulemaynot beco‐locatedwithanyothertransmitteror
antenna.
3) ForallproductsmarketinUnitedStates,OEMhastolimittheoperationchannelsinCH1
toCH11
for2.4Gbandbysuppliedfirmwareprogrammingtool.AndOEMshall
notsupplyanytoolorinfototheend‐userregardingtochangethedomainselection.
Aslongas3conditionsabovearemet,furthertransmittertestwillnotberequired.
However,theOEMintegratorisstillresponsiblefor
testingtheirend‐productfor
anyadditionalcompliancerequirementsrequiredwiththismoduleinstalled(for
example,digitaldeviceemissions,PCperipheralrequirements,etc.).

IMPORTANTNOTE:Intheeventthattheseconditionscannotbemet(for
examplecertainlaptopconfigurationsorco‐locationwithanothertransmitter),then
theFCCauthorizationis
nolongerconsideredvalidandtheFCCIDcannotbe
usedonthefinalproduct.Inthesecircumstances,theOEMintegratorwillbe
responsibleforre‐evaluatingtheendproduct(includingthetransmitter)and
obtainingaseparateFCCauthorization.

EndProductLabeling
Thistransmittermoduleisauthorizedonlyforuse
indevicewheretheantennamay
beinstalledsuchthat20cmmaybemaintainedbetweentheantennaandusers
Thefinalendproduct
mustbelabeledinavisibleareawiththefollowin
g:“ContainsFCCID:
2ACOE‐SKW92”.


ModuleAntennaType:PCBPINANT,1.5dBigain