Data Sheet

When the module is installed inside another device, the user manual of the host must contain below warning
statements;
1. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) (2) this device must accept any interference received, including interference that may cause undesired
operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
2. Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
The devices must be installed and used in strict accordance with the manufacturer's instructions as described
in the user documentation that comes with the product.
Any company of the host device which install this modular with limit modular approval should perform the test
of radiated & conducted emission and spurious emission,etc. according to FCC part 15C : 15.247,15B Class
B requirement, Only if the test result comply with FCC part 15C : 15.247,15B Class B requirement，
then the
host can be sold legally.
CE Statement
Herby,Skylab M&C Technology Co., Ltd declares that this SKB378 Datasheet BLE 5.2 Module，SKB378 is in
compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. In
accordance with Article 10(2) and Article 10(10), this product allowed to be used in all EU member states.
Use the SKB378 Datasheet BLE 5.2 Module in the environment with the temperature between -40℃ and
85℃
Operation Frequency:2402MHz~2480MHz
Max output power: BLE: 0.0018W
Manufacturer：
Skylab M&C Technology Co., Ltd
Address：6/F, Building9, Lijincheng park, Gongye East Road, Longhua St. Longhua District, Shenzhen,
Guangdong, 518109 China
E-mail: [e-mail]