Data Sheet

FCC Statement
FCC standards: FCC CFR Title 47 Part 15 Subpart C Section 15.247
PCB Antenna with antenna gain -3dBi
We will retain control over the final installation of the modular such that compliance of the end product is
assured. In such cases, an operating condition on the limit modular approval for the module must be only
approved for use when installed in devices produced by a specific manufacturer. If any hardware modify or
RF control software modify will be made by host manufacturer,C2PC or new certificate should be apply to get
approval,if those change and modification made by host manufacturer not expressly approved by the party
responsible for compliance ,then it is illegal.
FCC Radiation Exposure Statement
The modular can be installed or integrated in mobile or fix devices only. This modular cannot be installed in
any portable device. This modular complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter. This modular must be installed and operated with a minimum distance of 20 cm
between the radiator and user body.
OEM INTEGRATION INSTRUCTIONS:
This device is intended only for OEM integrator under the following conditions:
The module must be installed in the host equipment such that 20 cm is maintained between the antenna and
users, and the transmitter module may not be co-located with any other transmitter or antenna. The module
shall be only used with the internal on-board antenna that has been originally tested and certified with this
module. External antennas are not supported. As long as these 3 conditions above are met, further
transmitter test will not be required.
However, the OEM integrator is still responsible for testing their end-product for any additional compliance
requirements required with this module installed (for example, digital device emissions, PC peripheral
requirements, etc.). The end-product may need Verification testing, Declaration of Conformity testing, a
Permissive Class II Change or new Certification. Please involve a FCC certification specialist in order to
determine what will be exactly applicable for the end-product.
Validity of using the module certification:
In the event that these conditions cannot be met (for example certain laptop configurations or co-location with
another transmitter), then the FCC authorization for this module in combination with the host equipment is no
longer considered valid and the FCC ID of the module cannot be used on the final product. In these
circumstances, the OEM integrator will be responsible for re-evaluating the end product (including the
transmitter) and obtaining a separate FCC authorization. In such cases, please involve a FCC certification
specialist in order to determine if a Permissive Class II Change or new Certification is required.
Upgrade Firmware:
The software provided for firmware upgrade will not be capable to affect any RF parameters as certified for
the FCC for this module, in order to prevent compliance issues.
End product labeling:
This transmitter module is authorized only for use in device where the antenna may be installed such that 20
cm may be maintained between the antenna and users.
Information that must be placed in the end user manual:
The OEM integrator has to be aware not to provide information to the end user regarding how to install or
remove this RF module in the user's manual of the end product which integrates this module. The end user
manual shall include all required regulatory information/warning as show in this manual.