User Manual

MAX II

11.1 Transmitter and quadcopter are not paired.

Solution :

1) Ensure pairing was successful. If not, re-try.

2) Double check whether the installation of the blades is correct.

3) Confirm that the remote control is the original match. If not, re-start and then re-pair.

11.2 Unable to flip

Solution :

1) Press function combination button, which will change to flip mode.

2)Check if Li-po (battery) power is too low and needs to be recharged.

11.3 Quadcopter is shaking with noise :

Solution :

1) battery voltage is too low. Replce the battery with a new one.

2)Power OFF the quadcopter then restart.

3)Put the quadcopter on a level horizontal plane and recalibrate the gyroscope.

11.4 Cannot take off :

Solution :1)Wrong installation of the blade. Make sure the blades are connected to the right

motor.

2)Make sure quadcopter’s shell is not loose.

3)Check if the quadcopter battery is fully charged. If battery is too low, the inner light on the

quadcopter’s shell will flash.

The blades need to be installed in their

designated location. Blade A/B should be

installed to marked A/B on body or the

quadcopter will not operate properly.

Hold the head aiming towards the motor

axis and press down to lock. Be careful not

to damage or deform the blades.

Do not operate quadcopter under

bad weather conditions to avoid

any potential damages.

9. FLIGHT EMVIRONMENT :

10. INSTALL BLADES :

11. TRUOBLE SHOOTING