Owners manual

4. Check the transfer case shifter to see if it will move to 4L. If

not, the linkage will need adjusting as follows. Place the shifter

in 4L, loosen the adjustment bolt ("A" Arrow in Photo # 5), &

push the linkage ("B" Arrow in Photo # 5) forward until it stops.

Now retighten adjustment bolt. Check to be sure the 4WD

works properly.

5. On 5 speed models, engage the clutch & check the

transmission shifter to see if it will go into 2nd gear. If not, the

shifter housing on the floor will need trimming. Remove the

center console, pull back the carpet, remove the screws

holding the shifter boot to the floor, & trim or grind the floor

board until sufficient clearance is obtained. (See Arrow in

Photo # 6) Shift through each gear to check clearance at this

time. Now reinstall the shifter boot, carpet, & console.

Photo # 6

Photo # 5

I-TCL31 Pg 3

TORQUE SPECIFICATIONS

INCH SYSTEM

Bolt Size Grade 5 Grade 8

5/16 15 FT LB 20 FT LB

3/8 30 FT LB 35 FT LB

7/16 45 FT LB 60 FT LB

1/2 65 FT LB 90 FT LB

9/16 95 FT LB 130 FTLB

5/8 135 FT LB 175 FT LB

3/4 185 FT LB 280 FT LB

METRIC SYSTEM

Bolt Size Class 8.8 Class 10.9

6MM 5 FT LB 9 FT LB

8MM 18 FT LB 23 FT LB

10MM 32 FT LB 45 FT LB

12 MM 55 FT LB 75 FT LB

14MM 85 FT LB 120 FT LB

16MM 130 FT LB 165 FT LB

18MM 170 FT LB 240 FT LB

• The above specifications are not to be used when the bolt is being installed with a bushing.

Seat Belts Save Lives, Please Wear Your Seat Belt.