Owners manual
Pg 8I-JL3540BP
11. Install the new Skyjacker rear coil springs. Note: The new rear coil
spring with a "L" as the last digit of the part # is to be installed on the
Driver Side of the vehicle & the new rear coil spring with a "R" as the
last digit of the part # is to be installed on the Passenger Side of the
vehicle. Be sure when installing the new rear coil springs that the tabs of
each OEM rear upper coil spring isolator are aligned with the holes of
the OEM rear upper coil spring mounts.
12. Raise the rear differential in order to load the new Skyjacker rear coil
springs & install the new Skyjacker rear shocks using the supplied
polyurethane bushings, steel sleeves, OEM hardware & a 18mm socket
/ wrench. Note: The new rear shocks use the larger inside diameter
polyurethane bushings / longer steel sleeves for the rear upper shock
mounts & the smaller inside diameter polyurethane bushings / shorter
steel sleeves for the rear lower shock mounts. (See Photo # 12)
13. Install the OEM rear lower fender liners using the OEM hardware & a
8mm socket / wrench. (See Photo # 19)
14. Connect the OEM rear brake line brackets to the rear differential using
the OEM hardware & a 13mm socket / wrench. (See Photo # 21)
15. Install the new Skyjacker rear brake line brackets to the frame using the
OEM hardware & a 10mm socket / wrench. (See Photo # 24)
16. Slightly bend / straighten the OEM rear hard brake lines & connect the
OEM rear brake line brackets to the new Skyjacker rear brake line
brackets using the supplied 1/4" x 1" bolts, 1/4" washers, 1/4" nuts, & a
7/16" socket / wrench. (See Photo # 24) Note: Be very careful not to
damage the OEM rear hard brake lines.
17. Install the new Skyjacker rear sway bar end links using the supplied
polyurethane bushings, steel sleeves, 12mm x 65mm button head bolts,
7/16" USS washers, 12mm nuts, OEM hardware, a 5/16" hex key socket
/ wrench, & 18mm socket / wrench. (See Photo # 25) Note: Install the
new upper end link button head bolts from the outside of the vehicle
inward & the OEM lower bolts with the large / washer to the bushing
side of the new rear sway bar end links.
18. Install the rear tires / wheels using a 22mm socket & lower the rear of the vehicle to the ground. (See
Photo # 13)
19. Connect the OEM rear track bar to the new Skyjacker rear upper track bar bracket using the OEM
hardware & a 21mm socket / wrench. (See Photo # 15) Note: Install the OEM bolt with the threads
towards the rear of the vehicle.
Photo # 24
Photo # 25
Photo # 26