Owners manual

Pg 6I-JL3540BP
24. Install the new Skyjacker front sway bar end links using the supplied
polyurethane bushings, steel sleeves, 12mm x 70mm bolts, 7/16" USS
washers, 12mm nuts, OEM hardware, a 18mm socket / wrench, &
19mm socket / wrench. (See Photo # 13) Note: On the driver side of the
vehicle, install the OEM lower bolt with the large washer to the bushing
side of the new front sway bar end link.
25. Install the OEM front skid plate using the OEM hardware & a 13mm
socket / wrench. (See Photo # 2)
26. Install the front tires / wheels using a 22mm socket & lower the front of
the vehicle to the ground. (See Photo # 1)
27. Install the fixed end of the new Skyjacker adjustable front track bar to the
frame using the OEM hardware & a 21mm socket / wrench. (See Photo
# 14) Note: Do not tighten at this time.
28. Using a measuring tape, check the front of the vehicle to make sure the
body is centered over the front tires / wheels & adjust the new Skyjacker
rod end to align with the lower track bar mounting location.
29. Install the adjustable end of the new Skyjacker adjustable front track bar
to the front differential using the supplied rod end bushings, OEM
hardware, & a 21mm socket / wrench. (See Photo # 15) Note: Fully
tighten the OEM hardware at this time.
30. Tighten the supplied jam nut of the new Skyjacker adjustable front track
bar using a 1 1/8" wrench.
Rear Installation:
1. Block the front tires / wheels, raise the rear of the vehicle, support the
frame rails, & rear differential using jack stands.
2. Remove the rear tires / wheels using a 22mm socket. (See Photo # 16)
3. Remove the OEM rear sway bar end links
using a 6mm hex key socket / wrench &
18mm socket / wrench. (See Photo # 17)
Photo # 13
Photo # 14
Photo # 15
Photo # 16
Photo # 17