Owners manual

Pg 7I-JL1525BP
5. Disconnect the OEM rear track bar from the frame using a 21mm socket
/ wrench. (See Photo # 15)
6. In order to gain access to the OEM rear upper shock mounting bolts,
remove the OEM rear lower fender liners using a 8mm socket / wrench.
(See Photo # 16)
7. Remove the OEM rear shocks using a 18mm socket / wrench. (See
Photo # 17)
8. Disconnect the OEM rear brake line brackets from the rear differential
using a 13mm socket / wrench. (See Photo # 18)
9. While checking for appropriate slack in ABS lines, brake lines, differential
vent hose, & etc. Lower the rear differential & remove the OEM rear coil
springs.
10. JL15BP Kits: Install the new Skyjacker rear bump stop spacers to the
OEM rear bump stop pads using the supplied 5/16" x 1 3/4" button head
bolts, 5/16" washers, 5/16" nuts, a 3/16" hex key socket / wrench, & 1/2"
socket / wrench. (See Photo # 19)
11. JL25BP Kits: Install the new Skyjacker rear bump stop spacers to the
OEM rear bump stop pads using the supplied 5/16" x 1" bolts, 5/16"
washers, 5/16" nuts, & a 1/2" socket / wrench. (See Photo # 20) Note:
When installed, the longest angle on top of the new rear bump stop
spacers face toward the front of the vehicle.
12. Install the new Skyjacker rear coil springs. Note: The new rear coil
spring with a "L" as the last digit of the part # is to be installed on the
Driver Side of the vehicle & the new rear coil spring with a "R" as the
last digit of the part # is to be installed on the Passenger Side of the
vehicle. Be sure when installing the new rear coil springs that the tabs of
each OEM rear upper coil spring isolator are aligned with the holes of
the OEM rear upper coil spring mounts.
Photo # 16
Photo # 17
Photo # 19
Photo # 18
Photo # 20
Photo # 15