Owners manual

Pg 6I-JL1525BP
19. Connect the OEM vent hose to the front differential using pliers.
20. Connect the wiring harness to the OEM 4wd acuator. (See Photo # 9)
21. Connect the wiring harness to the passenger side OEM front upper
control arm.
22. Connect the OEM front brake line brackets to the OEM front lower
control arms using the OEM hardware & a 15mm socket / wrench. (See
Photo # 7)
23. Install the new Skyjacker front shocks using the supplied polyurethane
bushings, steel sleeves, OEM hardware & a 18mm socket / wrench.
Note: The new front shocks use the larger inside diameter polyurethane
bushings / longer steel sleeves for the front upper shock mounts & the
smaller inside diameter polyurethane bushings / shorter steel sleeves
for the front lower shock mounts. (See Photo # 11)
24. Install the new Skyjacker front sway bar end links using the supplied
polyurethane bushings, steel sleeves, 12mm x 70mm bolts, 7/16" USS
washers, 12mm nuts, OEM hardware, a 18mm socket / wrench, &
19mm socket / wrench. (See Photo # 12) Note: On the driver side of the
vehicle, install the OEM lower bolt with the large washer to the bushing
side of the new front sway bar end link.
25. Install the OEM front skid plate using the OEM hardware & a 13mm
socket / wrench. (See Photo # 2)
26. Install the front tires / wheels using a 22mm socket & lower the front of
the vehicle to the ground. (See Photo # 1)
27. Connect the OEM front track bar to the frame using the OEM hardware
& a 21mm socket / wrench. (See Photo # 4) Note: Slightly turning the
steering wheel will help align the OEM front track bar with the frame
mount.
Rear Installation:
1. Block the front tires / wheels, raise the rear of the vehicle, support the
frame rails, & rear differential using jack stands.
2. Remove the rear tires / wheels using a 22mm socket. (See Photo # 13)
3. JL15BP Kits: Disconnect the OEM rear sway bar end links from the rear differential using a 18mm
socket / wrench. (See Photo # 14)
4. JL25BP Kits: Remove the OEM rear sway bar end links using a 6mm hex key socket / wrench &
18mm socket / wrench. (See Photo # 14)
Photo # 11
Photo # 12
Photo # 13
Upper
Shock Mount
Photo # 14