Owners manual
Pg 5I-T4330STB
Rear Installation:
1. Block the front tires / wheels, raise the rear of the vehicle, & support
securely using jack stands.
2. While supporting the rear dierential, remove the rear tires / wheels.
3. Remove the OEM rear shocks & OEM rear sway bar end links. (See
Photo # 14)
4. Disconnect the OEM rear brake line brackets from the rear
differential.
5. Disconnect the OEM rear track bar from the OEM frame bracket. (See
Photo # 15)
6. Lower the rear dierential & remove the OEM rear coil springs.
7. Install the new Skyjacker rear coil springs using the OEM isolators /
bump stops. (See Photo # 16)
8. Raise the rear dierential to the new Skyjacker rear coil springs &
attach the OEM rear track bar to the OEM frame bracket.
9. Connect the OEM rear brake line brackets to the rear differential.
10. Install the new Skyjacker rear sway bar end links using the supplied
bushings, sleeves, 1/2" x 3" ne thread bolts, washers, & nuts. (See
Photo # 17) Note: Some models will require the OEM sway bar
eyelet to be drilled using a 1/2" drill bit. (See Photo # 18)
11. Install the new Skyjacker rear shocks using the OEM & supplied
hardware. (See Photo # 19)
12. Install the rear tires / wheels & lower the rear of the vehicle to the
ground.
Photo # 14
Photo # 15
Photo # 16
Photo # 19
Photo # 17
Photo # 18