Owners manual

14. Connect the OEM outer tie rods to the OEM steering knuckles using
the OEM hardware.
15. Connect the OEM ABS / brake lines to the OEM upper A-arms using
the OEM hardware. (See Photo # 9)
16. Connect the OEM sway bar end links to the OEM steering knuckles
using the OEM hardware. (See Photo # 9)
Note: 2007 - 2014 Toyota FJ Cruiser Models Proceed to Step # 27.
17. Remove the OEM front skid plate bolts. (See Photo # 10)
18. If equipped, remove OEM rear skid plate bolts.
19. Support the front differential using a floor jack.
20. Remove the OEM bolts from the OEM cross member & front differential
mounts. (See Photo # 11)
21. Lower the front differential & install the new Skyjacker differential
lowering spacers between the OEM cross member & front differential
mounts using the large OEM washers, supplied 1/2" x 6 1/2" coarse
thread bolts, washers, & nuts. (See Photo # 12)
22. Remove the floor jack from under the front differential.
23. Install the OEM front skid plate at the front mounting locations using the
OEM hardware.
24. Install the OEM front skid plate at the rear mounting locations using the
supplied crush sleeves, 8mm x 40mm bolts, & washers. (See Photo
# 13) Note: One new Skyjacker crush sleeve will be placed between the
OEM front skid plate & each OEM cross member / radiator support
bracket.
25. If equipped, install the OEM rear skid plate at the front mounting
locations using the supplied crush sleeves, 8mm x 40mm bolts, &
washers.
26. If equipped, install the OEM rear skid plate
at the rear mounting locations using the
OEM hardware.
27. Install the front tires / wheels & lower the
front of the vehicle to the ground.
Photo # 9
Pg 4I-T4330STB
Photo # 10
Photo # 11
Photo # 12
Photo # 13
Crush Sleeve