Owners manual

14. Install the strut assembly (See Photo # 5) into the strut
tower & start the 3 upper 10mm nuts. (Make sure
that the bottom of the strut is aligned as well)
15. Install the lower strut bolt in the original position that it
was removed.
16. Using a floor jack, raise the lower control arm & connect
the upper ball joint on the upper control arm to the
spindle.
17. Repeat steps 5 thru 16 for the opposite side.
18. Reconnect the sway bar end links & install the front
tires / wheels.
19. Lower the vehicle onto the ground & tighten the 3
upper strut tower nuts on both sides of the vehicle.
I-F920MS Pg 4
Photo # 4
Photo # 5