Owners manual

Component Box Breakdown:
Part #: F430STBH / F430STBM / F430STBN / F432STBH / F432STBM / F432STBN
Item # Description Qty Item # Description Qty
F423ST-S 3" 4WD FRONT STRUT 2 916X318X1114U 9/16 X 3 1/8 X 11 1/4 SQ U-BOLT 4
(Included With F430STBH, 916FTN 9/16 FINE THREAD LOCK NUT 8
F430STBM, & F430STBN Kits) H7060 HYDRO SHOCK W/RED BOOT 2
F4132ST-S 3" 2WD FRONT STRUT 2 (Included With F430STBH &
(Included With F432STBH, F432STBH Kits)
F432STBM, & F432STBN Kits) M9560 MONOTUBE SHOCK 2
F964ST-SP1 STRUT SPACER RING 2 (Included With F430STBM &
(Included With F430STBH, F432STBM Kits)
F430STBM, & F430STBN Kits) N8060 NITRO SHOCK W/RED BOOT 2
F964ST-SP1 STRUT SPACER RING 4 (Included With F430STBN &
(Included With F432STBH, F432STBN Kits)
F432STBM, & F432STBN Kits) I-F4302B INST SHEET: F430STB/F432STB 1
RBF202 2" FLAT DUAL PIN REAR BLOCK 2
I-F4302B Pg 2
Front Installation:
1. With the vehicle on a level concrete or asphalt surface, set the
emergency brake & block the rear tires / wheels. Place a floor jack
under the lower control arm front cross member & raise the front of
the vehicle. Place jack stands under the frame rails behind the front
wheel wells & lower the frame onto the jack stands.
2. Remove the front tires / wheels. (See Photo # 1)
3. Disconnect the OEM outer tie rod ends from the OEM steering
knuckles. Note: It may be necessary to strike the side of the OEM
steering knuckles to dislodge the OEM outer tie rod ends. Be careful
not to damage the OEM outer tie rod ends. (See Photo # 2)
4. Disconnect the OEM upper ball joints from the OEM steering
knuckles. Note: It may be necessary to strike the side of the OEM
steering knuckles to dislodge the OEM upper ball joints. Be careful
not to damage the OEM upper ball joints.
5. Disconnect the OEM lower strut mounts
from the OEM lower control arms. (See
Photo # 3)
Photo # 1
Photo # 2
Photo # 3