Owners manual

42. 6" Lift: Install the OEM steering stabilizer to the new Skyjacker
steering stabilizer frame bracket using the supplied 12mm x 60mm
bolt, washers, nut, & a 19mm socket / wrench. (See Photo # 15)
Note: The OEM steering stabilizer will mount to the top side of the
new steering stabilizer bracket mounting surface for a 6" lift.
43. 6" Lift: Install the OEM steering stabilizer to the new Skyjacker
steering stabilizer drag link bracket using the supplied 1/2" x 2 3/4"
fine thread bolt, washers, nut, & a 3/4" socket / wrench. (See Photo
# 17)
44. Install the new Skyjacker front shocks using the OEM hardware,
supplied hardware, a 18mm, & 19mm socket / wrench.
45. Connect the OEM sway bar end links to the OEM sway bar using
the OEM hardware & a 18mm socket / wrench.
46. Install the front tires / wheels using a 21mm socket & lower the front
of the vehicle to the ground.
Rear Installation:
1. Block the front tires / wheels, raise the rear of the vehicle, & support
securely using jack stands.
2. While supporting the rear differential, remove the rear tires / wheels
using a 21mm socket.
3. Disconnect the OEM passenger & driver side E-brake cables from the OEM cable unions &
disconnect the OEM driver side E-brake cable from the OEM frame bracket.
4. Disconnect the OEM E-brake cable brackets from the OEM frame bracket & OEM rear leaf
spring mount using a 13mm socket / wrench.
5. Install the new Skyjacker E-brake relocation bracket to the OEM frame bracket using the
supplied 1/2" x 1 1/2" fine thread bolt, 1/4" x 1" fine thread bolt, washers, nuts, a 7/16" socket /
wrench, & 3/4" socket / wrench. (See Photo # 18)
6. Connect the OEM driver side E-brake cable to the 1/2" diameter hole directly below the
previously installed 1/4" bolt of the new Skyjacker E-brake relocation bracket & connect the OEM
passenger side E-brake cable to the new Skyjacker E-brake cable bracket. (See Photo # 18)
7. Connect the OEM E-brake cables to the new Skyjacker E-brake cable bracket & connect the
OEM E-brake cable assembly to the OEM cable union. (See Photo # 19)
8. Install the new Skyjacker E-brake cable extension bracket to the OEM rear leaf spring mount
using the supplied 3/8" x 1" fine thread bolt, washers, nut, & a 9/16" socket / wrench. (See
Photo # 20)
Pg 8
I-F1745/65
Photo # 18
Photo # 19
Driver Side
Cable
Passenger
Side Cable
Photo # 20