Owners manual

Pg 4I-F1745/65
Item # Description Qty Item # Description Qty
F17RBE-B E-BRAKE CABLE LWR BRKT 1 38X1FTB 3/8 X 1 FINE THREAD BOLT 3
F960ECB E-BRAKE CABLE FRAME BRKT 1 38FTN 3/8 FINE THREAD LOCK NUT 3
F960ECE E-BRAKE CABLE EXTEN BRKT 1 38SAEW 3/8 SAE WASHER 6
14X1FTB 1/4 X 1 FINE THREAD BOLT 1 12X112FTB 1/2 X 1 1/2 FINE THREAD BOLT 1
14FTN 1/4 FINE THREAD LOCK NUT 1 12FTN 1/2 FINE THREAD LOCK NUT 1
14SAEW 1/4 SAE WASHER 2 12SAEW 1/2 SAE WASHER 2
Part # HB-F1768EC (Included With H-BOX F17651, F17651S, & F176513)
Item # Description Qty Item # Description Qty
34X2CTB 3/4 X 2 COARSE THREAD BOLT 8 34SAEW 3/4 SAE WASHER 16
34CTN 3/4 COARSE THREAD LOCK NUT 8
Part # HB-RAB545
Front Installation:
1. With the vehicle on flat level ground, set the emergency brake, &
block the rear tires / wheels.
2. Raise the front of the vehicle & support the vehicle securely using
jack stands.
3. While supporting the front differential, remove the front tires / wheels
using a 21mm socket.
4. Disconnect the OEM front sway bar from the frame using a 15mm
socket / wrench & install the new Skyjacker sway bar lowering
brackets to the frame using the OEM hardware & a 15mm wrench.
(See Photo # 1)
5. Connect the OEM sway bar to the new Skyjacker sway bar lowering
brackets using the supplled 7/16" x 1 1/2" fine thread bolts, washers,
nuts, & a 5/8" socket / wrench. (See Photo # 1)
6. Disconnect the OEM sway bar end links from the OEM sway bar using a 18mm socket / wrench.
7. Remove the retaining clip from each OEM ABS line & brake line bracket using pliers & remove the
OEM ABS line & brake line brackets from the frame using a 13mm socket / wrench. (See Photo
# 2)
8. Disconnect the OEM 4WD actuator lines from the upper frame.
9. Remove the OEM steering stabilizer from the OEM frame bracket & OEM drag link using a 15mm &
18mm socket / wrench.
10. Remove the OEM steering stabilizer bracket from the frame using a 13mm socket / wrench.
11. Disconnect the OEM drag link from the OEM pitman arm using a 24mm socket / wrench.
Photo # 1
Photo # 2