Owners manual

36. Rotate each OEM front flex brake line 180 degrees & secure to the new
Skyjacker brake line brackets using the OEM brake line retaining
clips thru the groove in each OEM brake line fitting. (See Photo
# 14)
37. While holding the OEM front hard brake lines in place, straighten
each OEM front hard brake line using a tubing bender & connect
the OEM front flex brake lines to the OEM front hard brake lines
using a 13mm & 16mm wrench. (See Photo # 14) Note: Be
extremely careful not to crimp or damage the OEM front hard
brake lines while straightening.
38. Attach the OEM drag link to the OEM pitman arm using the OEM
hardware & a 24mm socket / wrench.
39. Install the new Skyjacker steering stabilizer bracket to the frame
using the OEM hardware & a 13mm socket / wrench. (See Photo
# 15)
40. Install the OEM steering stabilizer to the new Skyjacker frame bracket
& OEM drag link using the OEM stud hardware, supplied 12mm x 60mm bolt, washers, nut, a
18mm, & 19mm socket / wrench. (See Photo # 15)
41. Install the new Skyjacker front shocks using the OEM hardware, supplied hardware, a 18mm, &
19mm socket / wrench.
42. Connect the OEM front sway bar end links to the OEM front sway bar using the OEM hardware & a
18mm socket / wrench.
43. Install the OEM fender liners using a T30 torx & 5.5mm socket / wrench.
44. Install the front tires / wheels using a 21mm socket & lower the front of the vehicle to the ground.
Rear Installation:
1. Block the front tires / wheels, raise the rear of the vehicle, & support securely using jack stands.
2. While supporting the rear differential, remove the rear tires / wheels using a 21mm socket.
3. Remove the OEM rear shocks using a 18mm & 21mm socket / wrench.
4. Remove the OEM u-bolts using a 24mm socket / wrench. Note: The rear differential will now be
free to move, support securely using a floor jack.
5. Lower the rear differential & install the new Skyjacker rear lift blocks with the taller end toward
the rear bumper, between the axle pad & the OEM rear block. Note: The new rear blocks will be
installed below the OEM rear blocks.
Pg 6
I-F1740SP
Photo # 14
Photo # 15