Owners manual

I-F1740SP Pg 5
24. Remove the OEM track bar bracket from the frame & front cross
member using a 18mm socket / wrench.
25. Install the new Skyjacker track bar bracket to the OEM location on
the cross member using the supplied 9/16" x 3” fine thread bolts,
washers, nuts, a 13/16", & 7/8" socket / wrench. Note: Use the
three .938” long anti-crush spacers between the front of the new
track bar bracket & the OEM cross member. Do not tighten at this
time. (See Photo # 9)
26. Complete the installation of the new Skyjacker track bar bracket to
the frame using the OEM hardware, & a 18mm socket / wrench.
(See Photo # 10) Note: Tighten the new track bar bracket
hardware at this time using a 18mm, 13/16", & 7/8" socket /
wrench.
27. Remove the OEM bump stops & bump stop cups from the frame
using a 10mm socket / wrench.
28. In order for the OEM bump stop cups to sit flush against the new
Skyjacker bump stop spacers, tap the locator tab on top of each
OEM bump stop cup flat using a hammer. (See Photo # 11)
29. Install the new Skyjacker bump stop spacers & OEM bump stop
cups to the frame using the supplied 8mm x 90mm bolts, washers,
thread locking compound, & a 13mm socket / wrench. (See Photo
# 12)
30. Install the OEM bump stops into each OEM bump stop cup. (See
Photo # 12)
31. Install the OEM front coil springs. (See Photo # 13) Note: Be sure
to reuse the OEM rubber isolator pads on top of each OEM front
coil spring.
32. Connect the OEM track bar to the new Skyjacker track bar bracket
using the OEM hardware, a 1 3/16”, & 1 1/4" socket / wrench .
33. Reconnect the OEM 4WD actuator lines.
34. Install the new Skyjacker brake line brackets to the frame using
the OEM hardware & a 13mm socket / wrench.
35. Disconnect the OEM front flex brake lines from the OEM front hard
brake lines using a 13mm & 16mm wrench.
Photo # 9
Photo # 10
Photo # 11
Photo # 12
Photo # 13