Owners manual

I-F1740SP Pg 3
Item # Description Qty Item # Description Qty
34X2CTB 3/4 X 2 COARSE THREAD BOLT 8 34SAEW 3/4 SAE WASHER 16
34CTN 3/4 COARSE THREAD LOCK NUT 8
Part # HB-RAB545
Item # Description Qty Item # Description Qty
716X112FTB 7/16 X 1 1/2 FINE THRD BOLT 6 716SAEW 7/16 SAE WASHER 12
716FTN 7/16-20 FINE N/I LOCK NUT 6
Part # HB-F54MS
Front Installation:
1. With the vehicle on flat level ground, set the emergency brake, &
block the rear tires / wheels.
2. Raise the front of the vehicle & support the vehicle securely using
jack stands.
3. While supporting the front differential, remove the front tires / wheels
using a 21mm socket.
4. Remove the OEM fender liners using a T30 torx & 5.5mm socket /
wrench.
5. Disconnect the OEM ABS module from the driver's side coil spring
tower using a 13mm socket / wrench.
6. Install the new Skyjacker ABS module bracket vertically to the driver's
side coil spring tower using the supplied 5/16" x 1" fine thread bolt,
washers, nut, & a 1/2" socket / wrench. (See Photo # 1)
7. Connect the OEM ABS module to the new Skyjacker ABS module
bracket using the OEM hardware & a 13mm socket / wrench. (See
Photo # 1)
8. Disconnect the OEM front sway bar from the frame using a 15mm
socket / wrench & install the new Skyjacker sway bar lowering
brackets to the frame using the OEM hardware & a 15mm wrench.
(See Photo # 2)
9. Connect the OEM front sway bar to the new Skyjacker sway bar lowering brackets using the supplied
7/16" x 1 1/2" fine thread bolts, washers, nuts, & a 5/8" socket / wrench. (See Photo # 2)
10. Disconnect the OEM front sway bar end links from the OEM sway bar using a 18mm socket / wrench.
11. Remove the retaining clip from each OEM ABS line & brake line bracket using pliers & remove the
OEM ABS line & brake line brackets from the frame using a 13mm socket / wrench. (See Photo # 3)
Photo # 2
Photo # 3
Photo # 1