Owners manual

33. Remove sway bar links from axle, and clamps from the frame
using 15mm socket. Remove sway bar and lay to the side.
(See Photo #29)
34. Remove draglink from pitman arm using 21mm socket.
Remove nut from steering box shaft using 1 5/16” socket.
Using pitman arm puller, remove pitman arm. Install new
Skyjacker EXTREME drop pitman arm. (See Photo #30)
35. Remove cotter pin from passenger side tie rod. Using 21mm
socket, remove nut from tie rod end. Removing the tie rod
from passenger side will allow access to track bar bolt. (See
Photo #31)
36. Remove cotter pin from track bar bolt on passenger side axle.
Using 18mm and 21 mm socket, remove the track bar bolt
and reinstall tie rod end. (See Photo #32)
37. Remove both upper and lower retaining nuts from shock using
21mm and 19mm socket. The top nuts can be reached from
under the hood. It may be necessary to remove air intake
hose to gain access to upper shock mount on driver side.
38. Remove upper shock tower ring bolts using 15mm socket.
(See Photo #33)
39. Connect a ratchet strap from pass side of axle to driver side
of frame. This will assure that axle does not move side to
side.
40. Disconnect the bracket on the driver and passenger side
frame rails that holds the brake line. This bracket will be
removed using a 13mm wrench. (See Photo #34)
41. Jack up the front of vehicle from frame rails while supporting
the front axle with jack stands.
42. Loosen upper and lower control arms using 21mm, 18mm,
and 15mm wrenches. (See Photo #35)
Photo #29
Photo #30
Photo #31
Photo #32
Photo #33
Photo #34
Photo #35
I-D7075 Pg 9