Owners manual

Photo #22
Photo #23
Photo #24
Photo #25
Photo #26
Photo #27
Photo #28
I-D7075 Pg 8
26. Install new cross-member with tabs down and pointing forward.
Install using 1/2” x 3 1/2” fine thread bolts, SAE washers and
self-locking nuts. Bolts should be installed so that they point
toward the front of vehicle.
27. Install factory rubber transmission mount to new upper trans-
mission bracket using factory hardware. Then, attach rubber
mount to new crossmember using 7/16” x 1 1/2” fine thread
bolts, washers, and self-locking nuts. (See Photo #22)
28. Clean backside of transmission mounting surface using Bristol
disc. Then, run a bead of silicone around rear outside edge of
transmission mounting surface. (See Photo #23)
29. Install transfer case using transmission jack. Transfer case will
be installed using flange nuts and washers. (See Photo #24
and #25)
30. Reinstall factory skid plate cross-member using 1/2” x 1 1/2”
fine thread bolts, SAE washers and self-locking nuts. (See
Photo #26)
31. Install new Skyjacker skid plate using 3/8” x 1 1/2” coarse
thread bolts. On outer bolt on passenger side, use two 1/4”
spacers between skid plate and cross-member. On the same
bolt you will use a washer and self-locking nut on backside.
(See Photo #27 and #28).
32. At this time tighten all bolts except lower arm relocation brack-
ets. Reconnect vent hoses and shift linkage. Also reconnect
vacuum lines being sure to connect the same as factory.