Owners manual
Photo #1
Photo #2
Photo #3
IMPORTANT NOTES: Safety Recall #835
1994-95 models 2500 and 3500 with 5.9 diesel or 8.0 ltr. V-10, The
vehicle manufacturer has a safety recall #835, which reinforces the
coil towers. The part # for this upgrade is #CBBR8352.Check with
your local dealer in regards to this upgrade prior to installing this
suspension system.
Front:
1. If equipped, remove factory skid plate that attaches to underside
of Transfer Case. Remove rear skid plate cross member.
“Located behind transfer case”. (See Photo #1 and #2)
2. Remove driver side exhaust bracket from rear of transfer case.
It will be reused at the end of the installation. (See Photo #3)
3. Remove front and rear drive shafts using 5/16” wrench @ axle
and 16mm socket @ transfer case. When rear drive shaft is
removed, fluid will run from transfer case. So, be prepared with
drip pan. (See Photo #4).
4. Drain fluid from transfer case. (See Photo #5).
5. Remove six retaining nuts that hold transmission to transfer
case. (See Photo #6)
6. Remove speedometer wire from rear of transfer case.
7. Remove vacuum line, vent hose from top of transfer case. (See
Photo #7)
I-D7075
Photo #4
Photo #5 Photo #6 Photo #7
Pg 5