Owners manual

Installation:
1. Park the vehicle on flat level ground & set the emergency brake.
2. Remove the OEM steering stabilizer.
3. Install the tapered stud into the tie rod & tighten.
4. Install the bushing & sleeve onto the body end of the new Skyjacker steering stabilizer & place
onto the OEM axle bracket & tighten.
5. Install the boot over the shaft of the new steering stabilizer & install the bushing. Mount the shaft
end of the new steering stabilizer to the the stud on the tie rod & tighten.
6. After installation of the steering stabilizer, cycle steering left to tight & check all components for
adequate clearance.
7. Re-tighten all hardware after the first 100 miles & periodically there after.
Seat Belts Save Lives, Please Wear Your Seat Belt.
1967 - 1987 GM 4x4
OEM Replacement Steering
Stabilizer
Part # 7055
I-7055 REV1 3-11
7000 WHITE STEERING DAMPER 1
HOURGLASS 5/8 HOURGLASS 5/8 SHOCK BUSHING 2
140629 EB6 STUD BAG - P932/140629 1
P837 STAB TAPERED STUD/141264 1
B10RS RED BOOT 1
BTIE RED BOOT TIE 1
HSS HYDRO SHOCK DECAL 1
Part # Description Qty
Contents:
www.skyjacker.com
Pg 1