User guide

Bracket “A”

Bracket “B”

Note: Skyjacker steering stabilizer Part # 7110 / 9110 is designed to fit several makes of vehicles

covering several years. Configuration of the front end of your vehicle will determine where you

mount the stabilizer. Differential cases are located either on left or right side depending on the

vehicle. This stabilizer can be installed on either side.

Installation:

1. Park the vehicle on a level concrete or asphalt surface with the front tires / wheels pointing

straight forward.

2. Set the emergency brake & block the rear tires / wheels.

3. Install the new Skyjacker bracket “A” to the axle housing tube using the supplied u-bolts,

washers, & nuts. (See Photo # 1) Install the new Skyjacker steering stabilizer onto the new brack-

et “A” using the supplied bushings, washers, & nut. (See Photo # 2)

4. Install the shaft end of the new Skyjacker steering stabilizer to the new Skyjacker bracket “B”

using the supplied bushings, washers, & nut. (See Photo # 2)

5. Extend the new Skyjacker steering stabilizer shaft out 4.44”(exactly half way) & mount to the tie

rod using the supplied u-bolts, washers, & nuts. Rotate the tie rod bracket as needed to obtain

the best position. (See Photo # 1)

I-7110 Pg 2

Photo # 1

Shock Stud

Stem Bushings

Retaining Washer

Bracket

Retaining Nut

Photo # 2