Owners manual

6. Install the new Skyjacker main bracket to the center
steering link using the supplied 516" u-bolts, washers, &
nuts. Measure from the center of the pitman arm 9” &
tighten the new main bracket. Adjust the main bracket as
needed, so both stabilizers are pulled out half way. (See
Photo # 4)
7. Attach both of the new Skyjacker steering stabilizers to the new
outer brackets & main bracket. (See Photo # 4 & # 5)
8. Once the new steering stabilizers are installed, check all brackets
& bolts for proper installation. Cycle the steering left to right &
check all parts for adequate clearance.
9. Retighten all hardware after the first 100 miles.
Seat Belts Save Lives, Please Wear Your Seat Belt.
I-7296 Pg 2
TORQUE SPECIFICATIONS
INCH SYSTEM
Bolt Size Grade 5 Grade 8
5/16 15 FT LB 20 FT LB
3/8 30 FT LB 35 FT LB
7/16 45 FT LB 60 FT LB
1/2 65 FT LB 90 FT LB
9/16 95 FT LB 130 FTLB
5/8 135 FT LB 175 FT LB
3/4 185 FT LB 280 FT LB
METRIC SYSTEM
Bolt Size Class 8.8 Class 10.9
6MM 5 FT LB 9 FT LB
8MM 18 FT LB 23 FT LB
10MM 32 FT LB 45 FT LB
12 MM 55 FT LB 75 FT LB
14MM 85 FT LB 120 FT LB
16MM 130 FT LB 165 FT LB
18MM 170 FT LB 240 FT LB
• The above specifications are not to be used when the bolt is being installed with a bushing.
Photo # 5
Photo # 4