Owners manual

98-02 Dodge 2500 & 3500
4WD Dual Steering Stabilizer
w/ 3 3/4" Front Axle Tube
Part # 7270
Contents:
2- 7000WS
1- Large Axle Bracket
2- Tie Rod End Brackets
4- P-932 Straight Studs
2- Axle Bracket U-Bolts w/Nuts & Washers
2- 5/16" x 1 1/4"x 1 3/16" U-Bolts – Passenger Side
2- 5/16" x 1 3/4"x 2 5/8" U-Bolts – Drivers Side
2- Boots & Boot Ties
I-7270 REV1 3-11 Pg 1
Installation:
1. Park the vehicle on flat level
ground & set the emergency
brake.
2. Turn the tires / wheels to a
straight forward position.
3. Place the new Skyjacker shock
boots over the new Skyjacker
steering stabilizers & secure
with the supplied boot ties.
4. Install the new Skyjacker axle bracket under the axle using
the supplied u-bolts, washers, & nuts. (See Photo # 1)
5. Attach the two P-932 straight studs to the new axle bracket &
mount one end of the steering stabilizers to each stud &
tighten.
6. Pull the steering stabilizers out 4 3/4" (exactly halfway). The
center to center eye length will be 19" when the steering stabilizers are 1/2 way out.
7. Install the new Skyjacker tie rod end brackets using the supplied u-bolts, washers, & nuts. When
mounted both tie rod brackets extrude forward & to the passenger side (See Photo # 2)
Note: Use the wider u-bolts on the driver’s side tie rod bracket.
8. Install a P-932 straight stud to each tie rod bracket
9. Cycle the tires / wheels fully to the left & right to make sure the steering stabilizers are adjusted
properly & that all brackets are secure. Check for clearance between all moving parts.
10. Re-torque all hardware after the first 100 miles & periodically thereafter.
Seat Belts Save Lives, Please Wear Your Seat Belt.
www.skyjacker.com
1

Summary of content (2 pages)