Owners manual

2005 - 2011 Ford Super Duty
Dual Steering Stabilizer
Part # 7254
PARTS LIST
ITEM# DESCRIPTION QTY
7000WS WHITE STEERING DAMPER 2
7254-B DUAL MAIN BRKT FOR 7254 1
B10RS RED BOOT 2
BTIE RED BOOT TIE 2
HSS HYDRO SHOCK DECAL 2
PARTS LIST
ITEM# DESCRIPTION QTY
7218-DB TIE ROD BRKT 1
7254-PB TIE ROD BRKT 1
38X334X412U 3/8 X 3 3/4 X 4 1/2 UBLT RD 2
516X112X214U 5/16 X 1 1/2 X 2 1/4 UBT RD 4
38CTN 3/8-16 COARSE N/I LOCK NUT 4
516CTN 516-18 COARSE N/I LOCK NUT 8
38SAEW 3/8 SAE WASHER 4
516SAEW 5/16 SAE WASHER 8
140629 EB6 STUD BAG - P932/140629 4
HOURGLASS 5/8 HOURGLASS 5/8 SHOCK BUSHING 4
Installation:
1. Park the vehicle on flat level ground & set the emergency brake.
2. Turn the tires / wheels to a straight forward position.
3. Place the new Skyjacker main bracket under the front axle against
the differential. Attach the new main bracket to the differential at this
point using the supplied 3/8” U-Bolts, washers, & nuts. (See Photo
# 1) With the new main bracket tightened, be sure to leave 1/8" to
3/16” of clearance between the bracket & tie rod assembly. Any more
clearance will cause stress to the polyurethane bushings of the new
steering stabilizers once installed. Any less may cause the tie rod to
rub the bracket.
4. Attach two of the new studs (Part #140629) on top of the main
bracket. (See Photo #2)
5. Install the new Skyjacker passenger side bracket to the tie rod
assembly using the supplied 5/16” u-bolts, washers, & nuts. Do not
tighten at this time. Attach one of the supplied studs (Part # 140629)
to the top of the passenger side bracket. (See Photo # 3) Repeat this
process on the driver side using the driver side bracket.
6. Assemble the new Skyjacker steering stabilizer cylinders by installing
the new Skyjacker shock boots then the hourglass bushings. Pull the
shaft of the cylinder out half way & install onto the studs of each
bracket. It will be necessary to adjust the tie rod brackets to line up
with the cylinders. Once lined up, tighten the tie rod brackets. (See
Photo # 4)
7. With both cylinders installed, cycle the steering left to right & check
for clearance between all parts. Retighten all hardware after the first
100 miles.
Note: Steering Stabilizer is designed to work on vehicles with a minimum 4” lift.
Photo #1
Photo #2
Photo #3
Photo #4
Photo #5
I-7254 REV1 3-11 Pg 1
www.skyjacker.com