Owners manual

Ford
Dual Steering Stabilizer
Part # 7240
Part # Description Qty.
7800 WHITE STEERING DAMPER 2
83540 UNIVERSAL DAUL MAIN B,FORD 1
83541 UNIVERSAL TIE ROD B,FORD 1
38X614X4U 3/8 X 6 1/4 X 4 U-BOLT SQ 1
516X114X134U 5/16 X 1 1/4 X 1 3/4 U-BT R 2
38CTN 3/8-16 COARSE N/I LOCK NUT 2
516CTN 516-18 COARSE N/I LOCK NUT 4
Part # Description Qty.
38SAEW 3/8 SAE WASHER 2
516SAEW 5/16 SAE WASHER 4
STEM BUSH-SST STEM BUSHING-STEERING STAB. 8
142120 STAB WASH PKG - P889/145098 4
B10RS RED BOOT 2
BTIE RED BOOT TIE 2
HSS HYDRO SHOCK DECAL 2
1. Park the vehicle on level ground & place the tires / wheels in a straight forward position. Set the
emergency brake & block the rear tires.
2. Install bracket "A" to the inside of the frame on the passenger side above the tie rod assembly & mount
using the large square u-bolt. Twist the bottom of the bracket forward then tighten the nuts on the u-bolt.
Note: On '92-'96 F-250 models, the bracket must either be tack welded in place or drill two 3/8" holes
through the frame using two of the holes in the bracket as a template & bolt to the frame.
3. Attach both stabilizer barrel ends to bracket "A" using the bushings & washers provided. Install the nut
provided & tighten.
4. Place the boots on the stabilizers. Attach bracket "B" to the stabilizer as shown, using the bushings &
washers provided. Install the nut provided & tighten.
5. Extend both stabilizer piston rods 4.44"(exactly half-way out) & place bracket "B" against the drag link as
shown & secure with the u-bolts, washers, & nuts.
6. Cycle the tires / wheels fully to right & to left making sure that no interference occurs & that the stabilizers
do not top or bottom out. Make adjustments as needed.
7. Re-check all hardware for tightness after the first 100 miles & check periodically thereafter & after every
off-road use.
Note: On F-350 vehicles with 6” or more of lift, the u-bolt supplied for the frame bracket will not
work. The bracket will need to be moved further down on the frame. Place the bracket in the
desired position on the frame & weld in place.
I-7240 REV1 3-11
Shock Stud
Stem Bushings
Retaining Washer
Retaining Washer
Bracket
Retaining Nut
Drag Link
Pg 1
www.skyjacker.com
Bracket “A”
Frame
Bracket “B”
Pitman Arm
Outer Tie Rod

Summary of content (2 pages)