Owners manual
Bracket “A”
Bracket “B”
Ford Ranger / BroncoII /
Explorer
Single Steering Stabilizer
Part # 7150
Part # Description Qty.
7900 WHITE STEERING DAMPER 1
83032 BACKING BRKT FOR 7150,7250 1
83031 MAIN BRKT - 7109,7150,KS150 1
83037 UNIVERSAL TIE ROD BRACKET 1
516X1X134U 5/16 X 1 X 1 3/4 U-BOLT RD 2
516CTN 516-18 COARSE N/I LOCK NUT 4
516SAEW 5/16 SAE WASHER 4
38X112FTB 3/8 X 1 1/2 FINE THRD BOLT 2
Part # Description Qty.
38FTN 3/8-24 FINE N/I LOCK NUT 2
38SAEW 3/8 SAE WASHER 2
STEM BUSH-SST STEM BUSHING-STEERING STAB. 4
142120 STAB WASH PKG - P889/145098 2
B10RS RED BOOT 1
BTIE RED BOOT TIE 1
HSS HYDRO SHOCK DECAL 1
Installation:
1. Park the vehicle on level ground & place the tires / wheels in a straight forward position. Set the
emergency brake & block the rear tires.
2. Place the main bracket “A” against the outside of the frame & backing plate on the inside of the frame &
install the bolts provided through the backing plate, through the slotted holes in the frame & main bracket.
(See Note Below)
3. Loosely install the tie rod bracket using the u-bolts, nuts, & washers provided. (Bracket “B”)
4. Attach the body end of the stabilizer to the main bracket & other end to the tie rod bracket.
5. Extend the stabilizer shaft out 4”(exactly half way) & mount in place. Rotate the tie rod bracket as needed
to obtain the best position. Tighten all hardware securely on the bolts & u-bolts at this time.
6. Cycle the tires / wheels left to right & check all hardware for clearance. Re-tighten after the first 100 miles
& periodically there after.
I-7150 REV1 3-11
Shock Stud
Stem Bushings
Retaining Washer
Retaining Washer
Bracket
Retaining Nut
Note: Models with a front sway bar will need to move bracket “A” back (away from the sway
bar) until clearance of the sway bar is obtained.
Pg 1
www.skyjacker.com