Owners manual
Ford Bronco II / Explorer /
F-150
Single Steering Stabilizer
Part # 7140
Part # Description Qty.
7800 WHITE STEERING DAMPER 1
83047 MAIN BRACKET FOR 7140W 1
83026 BACKING PLATE FOR 7140W 1
83037 UNIVERSAL TIE ROD BRACKET 1
516X114X134U 5/16 X 1 1/4 X 1 3/4 U-BT R 2
516CTN 516-18 COARSE N/I LOCK NUT 4
38X412FTB 3/8 X 4 1/2 FINE THREAD BLT 2
516SAEW 5/16 SAE WASHER 4
Part # Description Qty.
38FTN 3/8-24 FINE N/I LOCK NUT 2
38SAEW 3/8 SAE WASHER 2
STEM BUSH-SST STEM BUSHING-STEERING STAB. 4
142120 STAB WASH PKG - P889/145098 2
B10RS RED BOOT 1
BTIE RED BOOT TIE 1
HSS HYDRO SHOCK DECAL 1
Installation:
1. Park the vehicle on level ground & place the tires / wheels in a straight forward position. Set the
emergency brake & block the rear tires.
2. Place the stabilizer bracket “A”, long bracket, against the inside of the frame as shown. Place the backing
bracket on the outside of the frame. Install the bolts through the backing bracket & through bracket “A”.
Secure with nuts & washers. DO NOT TIGHTEN AT THIS TIME.
3. Attach the shaft end of the stabilizer to bracket “A” using the bushings & washers provided. Loosely attach
the stabilizer to bracket “B” then attach to the tie rod using the u-bolts & nuts supplied.
4. Attach the stabilizers to bracket “B” as shown, using the bushings & washers provided.
5. Extend the stabilizer piston rod 4.44” (exactly half-way out). Rotate brackets “A” & “B” as needed to obtain
the best position & tighten all hardware securely.
6. Cycle the tires / wheels left to right & check all hardware for adequate clearance.
7. Re-tighten all hardware after the first 100 miles & periodically there after.
I-7140 REV1 3-11
Shock Stud
Stem Bushings
Retaining Washer
Retaining Washer
Bracket
Retaining Nut
Pg 1
www.skyjacker.com
Bracket “A”
Bracket “B”