Owners manual

Bracket “A”
Bracket “B”
GM, Dodge, Ford, Jeep, Scout
Single Steering Stabilizer
Part # 7110
Part # Description Qty.
7800 WHITE STEERING DAMPER 1
83170 MAIN BRKT FOR 7110 1
83161 UNIVERSAL TIE ROD BRACKET 1
38X318X312U 3/8 X 3 1/8 X 3 1/2 RD/UBLT 2
516X114X134U 5/16 X 1 1/4 X 1 3/4 U-BT R 2
38CTN 3/8-16 COARSE N/I LOCK NUT 4
38SAEW 3/8 SAE WASHER 4
Part # Description Qty.
516CTN 516-18 COARSE N/I LOCK NUT 4
516SAEW 5/16 SAE WASHER 4
STEM BUSH-SST STEM BUSHING-STEERING STAB. 4
142120 STAB WASH PKG - P889/145098 2
B10RS RED BOOT 1
BTIE RED BOOT TIE 1
HSS HYDRO SHOCK DECAL 1
Note: Skyjacker steering stabilizer Part# 7110 is designed to fit several makes of vehicles covering several
years. Configuration of the front end of your vehicle will determine where you mount the stabilizer. Differential
cases are located either on left or right side depending on vehicle. This stabilizer can be installed on either
side.
Installation:
1. Park the vehicle on flat level ground & set the emergency brake.
2. Place the tires / wheels to a straight forward position.
3. Install bracket “A” to the axle housing tube per the illustration using the supplied u-bolts & nuts. Do not
tighten at this time. Install the stabilizer onto bracket “A” using the supplied bushings & washer packs.
4. Install the shaft end of the stabilizer to bracket “B”.
5. Extend the stabilizer shaft out 4.44”(exactly half way) & mount to the tie rod using the supplied u-bolts &
nuts. Rotate the tie rod bracket as needed to obtain the best position. Tighten all hardware securely at this
time.
6. Cycle the tires / wheels left to right & check all hardware for clearance. Re-tighten after the first 100 miles
& periodically there after.
I-7110 REV1 3-11
Shock Stud
Stem Bushings
Retaining Washer
Retaining Washer
Bracket
Retaining Nut
www.skyjacker.com
Pg 1

Summary of content (2 pages)