User's Manual

ComplianceInformation
FCC/ISEDCComplianceNotice
This devicecomplies with Part 15 of the FCC Rules and ISEDC Licenceexempt
RSSstandard.
Operationissubjecttothefollowingtwoconditions:
(1)Thisdevicemaynotcauseharmfulinterference,and
(2) This device must accept any interference received,including interference
thatmaycauseundesiredoper
ation.
Anychangesormodificationsnotexpresslyapprovedby thepartyresponsible
forcompliancecouldvoidtheusersauthoritytooperatetheequipment.

Cetappareilestconformeàlapartie15desrèglesdelaFCCetàlanormeRSS
exonéréedelicenceISEDC.
L’opérationestsoumiseauxdeuxconditionssuiv
antes:
(1)cetappareilnepeutpascauserd’interférencesnuisibles,et
(2) cet appareil doit accepter toute interférence reçue, y compris les
interférencesquipeuventcauserunfonctionnementindésirable.
Toute modificationoumodificationnonexpressémentapprouvéeparlapartie
responsable de la conformité pourrait annuler l’autorisation de l’utilisateur
d’utiliserl’équipement.

This devicehas been tested and found to comply with the limits for a Class B
digitaldevice, pursuant to Part 15 ofthe FCCRules. These limitsare designed
toprovidereasonableprotectionagainstharmfulinterferenceinaresidential
installation. This equipment generates, uses and can radiated radio frequency
energy and, if not ins
talled and used in accordance with the instructions,may
causeharmfulinterferencetoradiocommunications.
However,there is no guarantee that interference will not occur in a particular
installation If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment of
f
and on, the user is encouraged to try to correct the interference by one or
moreofthefollowingmeasures:
Reorientorrelocatethereceivingantenna.
Increasetheseparationbetweentheequipmentandreceiver.
Connect the equipment into an outlet on a circuit different fr om that to
whichthere
ceiverisconnected.
Consultthedealeroranexperiencedradio/TVtechnicianforhelp.

RFExposureInformation
SAR tests are conducted using standard operating positions accepted by the
FCC/ISEDCwiththedevicetransmittingatitshighestcertified powerlevelinall
testedfrequencybands,althoughtheSARisdeterminedatthehighes
tcertified
power level, the actual SAR level of the device while operating can be well
below the maximum value. Before a new model is a available for sale to the
public,itmustbetestedandcertifiedtotheFCC/ISEDCthatitdoesnotexceed
the exposure limit established by the F
CC/ISEDC, Tests for each product are
performed in positions and locations as required by the FCC/ISEDC. For
Handheldoperation,thisdevice hasbeen testedand meetsthe FCC/ISEDC RF
exposure guidelines when used with an accessory designated for this product
orwhenusedwithanaccessorythatcontainsnome
tal.
For faceup,10mm was used for test, this equipment should be installed and
operatedwithminimumdistance10mm.